- #SONY FIRMWARE UPDATE 6500 UPDATE#
- #SONY FIRMWARE UPDATE 6500 DRIVER#
- #SONY FIRMWARE UPDATE 6500 SOFTWARE#
- #SONY FIRMWARE UPDATE 6500 PASSWORD#
- #SONY FIRMWARE UPDATE 6500 PC#
#SONY FIRMWARE UPDATE 6500 UPDATE#
Start the update After automatically resetting, the following screen is shown and the update starts.Note: The Loading icon may not be displayed depending on the OS version that you are using. The camera will automatically be reset.Update is required Update is not required Turn off the camera, remove the battery pack, reinsert the battery and turn the camera back on.
#SONY FIRMWARE UPDATE 6500 SOFTWARE#
If the current system software version is 1.06 or later, the update is not required.In this case, disconnect the camera from the computer and click Finish. The current version number and updated version number appear on the lower left-hand side of the screen.After confirming that the current software version is "Ver. If this happens, remove the battery pack from the camera, reboot the computer and follow the instructions from "2. Sometimes, when the camera is connected to the computer with the USB cable, a message prompting you to restart the computer may be displayed. If the computer has multiple USB terminals, try with the other terminals.Disconnect the USB cable and connect it again.Note: If the computer cannot find the device, the message "Could not find the camera for this update" is displayed on the computer screen. "USB Mode" appears on the LCD screen of the camera. Connect the camera to the computer with the supplied USB cable.Following the instructions in the System Software Updater window, on the camera, select Menu > Setup subpage > USB Connection and check if Mass Storage has been selected.If a mode other than Mass Storage is selected, please select Mass Storage.Note: If the System Software Updater does not start up, double-click in the - folder to start up. The System Software Updater will start.Note: Never turn off the camera nor disconnect the USB cable while updating. If the message is displayed, close using the button. "USB Mode" appears on the LCD monitor of the camera.
#SONY FIRMWARE UPDATE 6500 PC#
Connect the camera to the PC using the USB cable (supplied).A dialogue box for the USB connection will be displayed.If both the message displayed and the "Security and Privacy" screen do not disappear, close both using the button.If the "Security and Privacy" screens does not disappear, please close the window.If you are asked to restart macOS after clicking the button, please restart and return to the beginning of the update procedure.Note: If you have approved this in the past, the security and privacy screen will not be displayed. Open the "General" tab on the "Security and Privacy" screen and allow reading of the "Sony Corporation" system software.If the following message is displayed before "Security and Privacy" is displayed, press the button.Once the message from the system displays, the security and privacy screen will be displayed.
If your computer is running on another OS, follow the procedure below.
#SONY FIRMWARE UPDATE 6500 DRIVER#
Go to the download page below, follow the instructions, and download the Driver Loader to start the updater. If your computer is running on macOS 10.15, you also need to download the Driver Loader. Go to the download page below, follow the instructions, and download the System Software Update Helper to start the updater. If your computer is running on macOS 11, you also need to download the System Software Update Helper.
#SONY FIRMWARE UPDATE 6500 PASSWORD#
Type the password for the administrative account.